JUMO 709062 TYA 202 - Three-Phase Power Controller Operating Manual - Manual (Page 7)

2012-12-31/00561073 [SCR power switch TYA202] 5
Content
7 Setup program ......................................................................... 85
7.1 Hardware .................................................................................................. 85
7.2 Compatible operating systems ............................................................... 85
7.3 Installation ................................................................................................ 86
7.4 Program start ........................................................................................... 88
7.5 Forgotten the code? ................................................................................ 89
7.6 Changing the language of the device texts ........................................... 90
8 Fault messages and alarms .................................................... 91
8.1 Binary signal for collective fault ............................................................. 95
8.2 Replacing a defective semi-conductor fuse ......................................... 96
8.2.1 Accessories: semi-conductor fuses .................................................................. 97
8.2.2 Semi-conductor fuses type 709062/X-0X-20... ................................................. 97
8.2.3 Semi-conductor fuses type 709062/X-0X-32... ................................................. 98
9 What to do, if ... ...................................................................... 101
10 Technical data ........................................................................ 103
10.1 Voltage supply, load current ................................................................. 103
10.2 Electrical isolation ................................................................................. 103
10.3 Analog inputs (master only) .................................................................. 104
10.4 Analog output (actual value output master only) ................................ 104
10.4.1 Display and measuring accuracy ..................................................................... 104
10.5 Binary inputs ........................................................................................... 104
10.6 Binary output (fault signal output master only) ................................... 104
10.7 General characteristic data ................................................................. 105
10.8 Approvals / approval marks .................................................................. 107