JUMO 709062 TYA 202 - Three-Phase Power Controller Operating Manual - Manual (Page 44)

4 Operation
42 2012-12-31/00561073 [SCR power switch TYA202]
1. Is only displayed if the current transformer is fitted (option I 2 - / I- or P control)
2. Is not displayed if the subordinate control loop is switched off
3. Is only displayed for phase angle control mode
4.
Is only displayed in half-wave control operating mode
4.1.4 Display in the configuration level
Scroll bar The entry highlighted in black is selected and contains further parameters.
If there are more than 3 entries in one level, a scroll bar that shows the current
position in the menu appears.
Navigation
Numerical entry
or
selection Once you have reached the required parameter, the or key can be
used to enter a numerical value or to select a parameter.
h Save the setting using
.
If you do not want to apply the value, the entry can be aborted by selecting
.
Device
temperature
Currently measured temperature inside the master power controller °C or °F
Slave device
temperature
Currently measured temperature inside the slave power controller °C or °F
Current input Measured value of the current input - measured on the master pow-
er controller
between terminals 1 and 2 on X2_1
mA
Voltage
input
Measured value of the voltage input - measured on the master
power controller between terminals 3 and 4 on X2_1 V