JUMO 709062 TYA 202 - Three-Phase Power Controller Operating Manual - Manual (Page 49)

2012-12-31/00561073 [SCR power switch TYA202] 47
4 Operation
This function is not configured ex works.
This window only appears if the following setting has
been made in the configuration level:
h Press the
key to switch to the configuration
level
h Set Monitoring r
Teach In type load monit.
r
Manual
h Press the
key
The "ManualTeach-In" function is now configured.
h Change to the operator level r Monitoring r Load
monit.Teach-In
h Press the
key
A screen now appears asking whether the state should
be applied now. If so:
h Press the
key to apply the current load state as
the OK status.
A change in the load (load error) will be evaluated by the
device on the basis of this status.
k
/ bold = factory setting