ETC SmartPack v2.1.0 - Manual (Page 20)

16 SmartPack User Manual
General Settings
The General Settings menu is used to configure standard features of your SmartPack
dimmer pack including:
Set Language
Multiple language options to choose from:
• English
• Francais
• Deutsch
• Espanol
LCD BackLight
User-selectable LCD backLight performance:
• Auto - LCD dims when not in use for period of time
• On - always on
• Off - always off
Menu Mode
User-selectable Normal Menu or Advanced Menu:
• Normal - limited menu options allowing users only to change the DMX Start Address
from the DMX menu, view the Software Version and change menu mode from the
General Settings menu.
• To enter Normal mode from the Advanced menu, scroll to [Normal] and press .
The SmartPack will request confirmation that you want to exit the Advanced menu,
scroll to [Yes] and press .
• Advanced - all menu access.
• To enter Advanced mode from the Normal menu, scroll to [Advanced] and press
and hold for 5 seconds. The menu will adjust back to the main menu
automatically, without further prompt.
Reset To Defaults
Resets the following attributes to default status:
• Dimmer Curves - set to >Mod SQR Law<
• DMX Start Address - set to start address >1-3, 1-6, or 1-12<
• DMX Loss Behavior - resets to >Hold Last Look<
Deep Clear System
Resets the unit as if it were new, out of the box including the following attributes:
• Resets same defaults as indicated in Reset to Defaults
• Clears presets and preset timing values to default values
• Resets Language and prompts the user for language selection
Software Version
Displays current software version