Setup preset timing, Activate a preset, Deactivate a preset – ETC SmartPack v2.1.0 User Manual
Page 16: Sequencer, Setup a sequence, For best
12
SmartPack User Manual
Setup Preset Timing
Step 1:
Scroll to Presets menu, press .
Step 2:
Scroll to Setup Timing, press . Setup Timing, Preset / Step: [##] will display.
Step 3:
Press + or - to scroll the presets list. Press , Fade Up [min]:03 will display.
Step 4:
Press + or - to increase or decrease the Fade Up minutes. Press . The
selection will change to the seconds field.
Step 5:
Press + or - to increase or decrease the Fade Up seconds. Press . Fade Down
[min]:03 will display.
Step 6:
Repeat steps 4 and 5 for Fade Down. Press . Hold Time [min]:00 will display.
Step 7:
Repeat steps 4 and 5 for Hold Time. Press when done.
Activate a Preset
Step 1:
Scroll to Presets menu, press .
Step 2:
Scroll to Activate Preset and press , Number [##] will display.
Step 3:
Press + or - to scroll the list of presets. Press to select a preset.
Step 4:
“Preset ## Run Instant?” will display briefly.
a: To run the preset with its programmed Fade Up and Fade Down times,
ignore the “Run Instant?” message. The display will return to the previous
menu after a few seconds of display.
b: Press to complete the preset in the default time of 3 seconds. The display
will default to the previous menu.
Deactivate a Preset
If a Preset is active, the control symbol located in the top right corner of the LCD will display
the preset number and the P symbol. To deactivate the preset:
Step 1:
Scroll to Presets menu, press .
Step 2:
Scroll to Deactivate Preset and press . “Preset Deactivated” will display briefly
then returns to the previous menu.
Sequencer
The built in sequencer in SmartPack plays a series of recorded presets sequentially.
The order of execution is based on the first preset and the length is determined by the
number if steps configured for the sequence. Fade Up, Fade Down and Hold Times are
determined in the preset menu and may be different for each preset. The sequence can be
set to loop continuously or stop after only one occurrence.
Setup a Sequence
Step 1:
Scroll to Sequencer, press .
Step 2:
Scroll to Setup Sequence, press .
Step 3:
Use + or - to select the number of steps to be included in the sequence (up to
32). The Sequencer will play the steps in series with preset one as step one
always. Press , Loop: [NO] will display.
Step 4:
Scroll to select [Yes] to continuously loop the sequence or [No] to play the
sequence only once and then stop. Press .