AirLive AirMax5 - Manual (Page 128)

10. Frequent Asked Questions
121 AirLive AirMax5 User’s Manual
====================================================================
Question
: Where is the signal survey function that displays the RSSI value continuously?
Answer: The “Signal Survey” function is inside the Site Survey function. You can
access from “Operation Mode -> Setup -> Site Survey” menu.
====================================================================
Question : When do I use Per-User Bandwidth Control by IP, MAC, or IP segment?
Answer:
‰ IP address: When you want to limit the bandwidth of a single notebook
computer, PC, or WISP router.
‰ MAC address: When you want to limit the bandwidth of a remote CPE
in Client mode.
‰ IP Segment:: When you want to limit the bandwidth of an entire IP range.
For example, all the PCs using the DHCP server to get IP addresses
.
====================================================================
Question : When I use “Site Survey”, why does the RSSI LED goes off?
Answer: When you click on the Site Survey, the AirMax5 thinks you are trying to
choose a new network to associate. Therefore, it will disconnect from
current connection and wait until you establish a new connection. If you
require seeing the wireless link quality after connection is established, please go to
“
Device Status->Wireless ” menu to see the “ RSSI ” value.
====================================================================