JLG 340AJ Service Manual - Manual (Page 241)

SECTION 5 - HYDRAULICS
3121259 – JLG Lift – 5-83
17. Torque sequence.
Install capscrews. While observing the torque sequence
shown, pre tighten the capscrews. Then, using a torque
wrench, tighten them to the proper torque.
Torque 44-54 Nm (32-40 ft.lbs.).
18. Install socket head capscrews.
Using a 4 mm internal hex wrench, install the socket
head capscrews to the front flange and rear cover.
Torque 2.5-3.4 Nm (22-30 ft.lbs.).
If used, install new o-ring to flange pilot.