Eppendorf R Series 48R CO2 Incubator - Manual (Page 16)

16
CO48R-0050 Š Galaxy R Series 48 R Personal Size CO
2
Incubator User’s Guide
Install the shelf racks and shelves, and level the incubator:
1. Each wire shelf rack has silicone suction cups that hold the rack in place. Install the
silicone suction cups onto the wire rack supports (7 per rack, each marked with an
asterisk in Figure 1a below).
2. Note that there are lefthand and righthand racks. The suction cup marked R
(“Rear”) goes to the rear of the chamber as shown in Figure 1b below. The suction
cups will adhere to the chamber walls even if they are dry; but if you feel it is
necessary, you can dampen them with distilled water to increase adhesion.
3. Ensure the shelf racks are installed squarely in the chamber so the shelves will sit
on a level plane (see Figure 1c below).
Figure 1: Installing Shelf Racks
a b c
4. Install the three shelves, making sure that each shelf’s anti-tip tab is properly
inserted onto each of the wire shelf rack guides (see Figure 2 below).
Figure 2: Installing Shelves
1 Anti-tip tab
R
1