Pioneer SC-LX90 - Manual (Page 123)

Additional information 13
123
En
iPod messages
i.LINK messages
You may see the following messages displayed in the front LCD display when using the i.LINK interface.
Meaning of messages displayed when the HDMI control function is set to ON
Symptom Cause Action
Error I1 There is a problem with the signal path from the
iPod to the amplifier. Switch off the amplifier and reconnect the iPod to the
amplifier. If this doesn’t seem to work, try resetting your iPod.
Error I2 The software version being used with the iPod
needs to be updated. Update the software being used with the iPod (please use the
latest iPod software versions later than the iPod updater 2004-
10-20).
Error I3 When operation is not possible with the iPod
operation mode set to
Type 1.
Switch the iPod operation mode set to Type 2 (page 58).
When the iPod software version is too old. Update the iPod software to the latest version.
Error I4 When there is no response from the iPod. Update the iPod software to the latest version.
No Music Track There are no playable songs currently stored in
the iPod. Input some music files compatible with iPod playback. When
you want to play videos, press
iPod CTRL to play the video
track using the controls on the iPod.
No Track When there are no tracks in the category
selected on the iPod. Select a different category.
Message Explanation
BUS FULL The i.LINK bus has reached its capacity and cannot transmit any more data.
CANNOT LINK 1 The connection between the amplifier and the selected i.LINK-equipped component is unstable. If the
i.LINK cables appear to be connected properly and both the amplifier and i.LINK-equipped component are
on, switch both units off, then on again to re-establish the connection between them.
CANNOT LINK 2 The amplifier can’t identify the selected i.LINK-equipped component. For example, the amplifier may not be
able to identify an i.LINK-equipped personal computer.
LINK CHECK The amplifier is checking the i.LINK network. It does this when components are added to, or removed from
the network. The sound may be interrupted if this happens during playback.
LOOP CONNECT The i.LINK network cannot function because the connected components form a loop. See The Input Setup
menu on page 94 for more on this.
NO NAME When an i.LINK-equipped component has no name, this message is displayed instead of the proper
component name.
NO SIGNAL A component is outputting an i.LINK signal that the amplifier cannot reproduce. This amplifier can only
reproduce signals from i.LINK-Audio-equipped components. See
About i.LINK on page 59 for more on this.
PQLS OFF This is displayed on a playback component when PQLS turns off during playback. The sound may be
interrupted momentarily when this happens.
PQLS ON This is displayed on a playback component when PQLS turns on during playback. The sound may be
interrupted momentarily when this happens.
UNKNOWN When an i.LINK-equipped component name cannot be recognized, this message is displayed instead of
the proper component name.
Message (error number) Problem Remedy
HDMI C ERR 110 to 190
HDMI C ERR 1A0
HDMI C ERR 1B0
HDMI C ERR 1C0
HDMI C ERR 2C0 HDMI cable is not properly connected. • Check the connection.
• There may be a broken wire in the cable.
• This amplifier or connected components may be damaged.
SC_LX90_WY.book Page 123 Wednesday, February 6, 2008 11:49 AM