Konica Minolta bizhub 421 - Manual (Page 261)

501/421/361 9-44
Administrator mode settings 9
9.5 Administrator Settings (IP/I-FAX)
This section explains Administrator settings specified for Internet fax and IP address fax operations.
9.5.1 System Settings - Power Save Settings - Enter Power Save Mode
For the setting procedure, refer to "System Settings - Power Save Settings - Enter Power Save Mode"
on page 9-14 .
9.5.2 System Settings - Restrict User Access
Restrict Access to Job Settings - Changing Job Priority
For the setting procedure, refer to "Restrict Access to Job Settings - Registering and Changing
Addresses" on page 9-9 .
Restrict Access to Job Settings - Change the "From" Address
For the setting procedure, refer to "Restrict Access to Job Settings - Change the "From" Address (E-
Mail)" on page 9-10 .
!
Detail
The From address is the address specified for the device.
Restrict Operation - Restrict Broadcasting
For the setting procedure, refer to "Restrict Operation - Restrict Broadcasting" on page 9-10 .
9.5.3 System Settings - Stamp Settings - Fax TX Settings
For the setting procedure, refer to "System Settings - Stamp Settings - Fax TX Settings" on page 9-15 .
9.5.4 Network Settings - Network Fax Settings
Network Fax Function Settings
For the Network Fax Function Setting procedure, refer to User’s Guide [Network Administrator].
SMTP TX Settings
For the SMTP TX setting procedure, refer to User’s Guide [Network Administrator].
SMTP RX Settings
For the SMTP RX setting procedure, refer to User’s Guide [Network Administrator].
9.5.5 Fax Settings - Header Information
For the setting procedure, refer to "Fax Settings - Header Information" on page 9-16 .
!
Detail
For RTI, [Outside Body Text] cannot be used for Internet fax/IP address fax. Even when [Outside Body
Text] is selected, the information is attached inside the body text.
9.5.6 Fax Settings - Header/Footer Position
For the setting procedure, refer to "Fax Settings - Header/Footer Position" on page 9-18 .
9.5.7 Fax Settings - Line Parameter Setting (IP)
Number of Redials
For the setting procedure, refer to "Number of Redials" on page 9-22 .
Redial Interval
For the setting procedure, refer to "Redial Interval" on page 9-22 .