Konica Minolta BIZHUB 223 - Manual (Page 222)

bizhub 423/363/283/223 10-28
10.11 Using the timer functions 10
10.11 Using the timer functions
Configure the Power Save and Weekly Timer functions.
The power save function has two modes: Low Power and Sleep. More electric power will be saved in the
Sleep mode when compared with the Low Power mode. However, the Sleep mode takes more time to warm
up this machine than the Low Power mode. Select the mode appropriate to your application.
The Weekly Timer function allows you to specify the time before transition to the Sleep mode in units of days
or weeks. You can control the power saving according to your application.
[Power Save Setting]
In the administrator mode of PageScope Web Connection, select [Maintenance] ö [Timer Setting] ö [Pow-
er Save Setting].
Item Description
[Low Power Mode Set-
ting] Enter a time interval before transition to the Low Power mode since the last
operation of this machine.
[Sleep Mode Setting] Enter a time interval before transition to the Sleep mode since the last opera-
tion of this machine.
[Power Save Key] If you do not operate this machine for a long time, you can forcibly switch this
machine to the power saving mode by pressing the Control Panel key on the
Power Save.
Select the mode this machine will transition to when you press the Power
Save key.
[Enter Power Save
Mode] Specify how to return to the Power Save mode after printout of the fax docu-
ment that was received in the Power Save mode.
Setting this item to [Immediately] returns this machine immediately after re-
ceiving a fax while it is not being used (in the night for example), thus saving
the electric power more efficiently.
If you set this item to [Normal], this machine returns to the Power Save mode
after the specified transition time has elapsed.
[Fax Board Power
Save] Specify whether to enable power save mode.
When [ON] is specified, the fax board will not enter the power save mode in
the following situations:
•
Number of RX Call Rings is set to 0.
• TEL/FAX Auto Switch is enabled.
• Disconnect External Telephone is set to [ON].