Lenovo ThinkPad R61i - Manual (Page 94)

Table 26. RRcmd parameters (continued)
Command Result
Copy Copy backups from one location to another. This command is also
known as archive and must include the location.
Rejuvenate Rejuvenate operating system to the specified backup.
Delete Delete backups. This command must include the location.
Changebase Change files in all backups based on file.txt contents. Options in
file.txt are:
A Add
D Delete
R Replace
Migrate Create migration file from a backup.
Filter=filterfile Files and folders that will be restored. This command is used only
with the Restore command.
Location=c One or more of the following can be selected with the associated
result:
L For primary local hard drive
U For USB hard drive
S For second local hard drive
N For network
C For CD/DVD Restore
name=abc Where abc, is the name of the backup.
level=x Where x is a number from 0 (for the base) to maximum number of
incremental backups (only used with the restore option. For
backup commands, the level=x command is only required if
performing an administrator backup (equal to or greater than 100,
for example).
Notes:
1. To restore from the latest backup, do not provide this
parameter.
2. All backup and restore features are routed through the service
so that the appropriate sequencing can be maintained,
callbacks are performed, for example. The backup command is
replaced with the command-line options.)
Boot manager
Configuration File
Format The format of the boot manager configuration file is backward
compatible with the previous version of boot manager. Any switch
not show below is not supported. The file format is a text file with
each entry is on a separate line.
Osfilter This command is used only with the restore command. It uses the
registry settings for OsAppsList to filter files being restored. This
command line entry can be used to do an OsApps restore.
86 Rescue and Recovery 4.21 Deployment Guide