Lenovo ThinkPad R61i - Manual (Page 36)

EFS file limitation
The date and time stamp attributes are not preserved for EFS files restored by
Rescue and Recovery, all other files will retain their original date and time.
Battery power settings for backups
With the corresponding ADM file installed for Rescue and Recovery, if you have
the Battery Percent Requirement set in Group Policy at 1% in the following ADM
path: ThinkVantage\Rescue and Recovery\Settings\Backup, and the system that you
are attempting to backup has 1% remaining battery power, set the following policy
to Hide the No Battery user message:
ThinkVantage\Rescue and Recovery\Settings\User Messages
For more information on Active Directory configurations for Rescue and Recovery
using Group Policy, see the accompanying XML/ADM Supplement for the
deployment guide located on the ThinkVantage Technologies Administrator Tools
page:
http://www.lenovo.com/support/site.wss/document.do?lndocid=TVAN-
ADMIN#tvsu
Completing a backup
Applications installed or uninstalled after the selected backup is created might
need to be installed again to function correctly. Make sure that the system is
connected to an AC power supply before initiating a backup, restore, rejuvenation,
or archive procedure. Failure to do so can result in data loss or an irretrievable
system failure.
Microsoft Message Queuing (MSMQ)
If you are using MSMQ, you might have problems starting the service after a
restore from an incremental backup. That is how Rescue and Recovery knows what
files have changed so it can back them up. So, if all those files aren’t backed up on
an incremental, then the files could get out of synch and cause the service to fail.
Here are some registry settings that run a command before Rescue and Recovery
takes a backup that sets the Archive bit on all files in the MSMQ directory. This
means the entire directory will be backed up every incremental.
[HKEY_LOCAL_MACHINE\SOFTWARE\Policies\Lenovo\Rescue and Recovery\Settings\Backup
\PreBackup]
"Pre"="cmd"
"PreParameters"="/c attrib +A \"%windir%\\system32\\msmq\\*.*\" /S /D"
"PreShow"=dword:00000000
Rescue and Recovery in the Windows environment
The following sections provide information on using Rescue and Recovery in the
Windows environment and in the Predesktop Area.
Using Rescue and Recovery in the Windows environment
The Rescue and Recovery program in the Windows environment enables you to
perform numerous types of backups. The following information instructs you on
how to use backup files with Rescue and Recovery.
Include and exclude backup files with registry settings
Rescue and Recovery can include and exclude an individual file, a folder, or an
entire partition. With Rescue and Recovery 4.21, these capabilities are controlled by
the following registry entries which are the type REG_MULTI_SZ:
28 Rescue and Recovery 4.21 Deployment Guide