Kramer Electronics SV-551 - Manual (Page 39)

Creating a Macro
35
Figure 41: Select Button Color
5.2.8 The Ignore Button Command
To write a Button Ignore command (see Figure 42 ) on an RC button (for
example, button 1), do the following:
1. Select the IGNORE BUTTON Port.
2. In the RC command area, write the command description (for example, Ignore
Button 4).
3. Select the Button ID (from 1 to 6) to which this command refers
1
4. Set the state of the button (Ignore, Unignore), for example, Ignore.
, for example
button 4.
Figure 42 illustrates the RC Command area as it appears after writing the
command to button 1:
1 For example, the command is written to button 1 but refers to an action taken for button 4