Kramer Electronics SV-551 - Manual (Page 33)

Creating a Macro
29
5. Repeat this process to add new commands. Click Duplicate to duplicate the
command and delete a command by clicking the Delete button.
6. If required, set a delay time after the command.
5.1 Labeling the Buttons
For your convenience, you can label the buttons in the Keypad tab area, as
illustrated in the example in
Figure 32 .
Figure 32: Labeling the RC Buttons
To label a button:
1. Open the Kramer RC Configuration main window.
2. Select a button.
3. Type the button text in the Label area:
Figure 33: Typing the Label
5.2 Creating a Driver Command
The driver commands for each port are slightly different. The following
sections describe how to write a new command for the different ports.
Each machine has a different set of commands, as defined in Table 1