Kramer Electronics SV-551 - Manual (Page 36)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Creating a Macro
32
5.2.4 A Switcher Command
Use the Switcher command to select an input connected to the Kramer
SV-551 (Video 1, Video 2, PC 1, PC2 and PC 3). The switcher command
applies to the master-slave configuration only.
To write a switcher command on an RC button, do the following:
1. Select the SWITCHER Port.
2. In the RC command area, write the command description (for example,
Select).
3. Select the switcher command (for example, Video 1).
Figure 37 illustrates the RC Command area as it appears after writing the
command:
Figure 37: Switcher RC Command
5.2.5 A Power Amplifier Command
To write a power amplifier command
1
1. Select the POWER_AMP Port.
on an RC button, do the following:
2. In the RC command area, write the command description (for example, High
Volume).
3. Select the power amplifier command (for example, Volume set).
4. Move the sliding switch to the desired volume (for example, 12dB).
Figure 37 illustrates the RC Command area as it appears after writing the
command:
1 For the Master-Slave configuration only