Kramer Electronics SV-551 - Manual (Page 38)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Creating a Macro
34
5.2.7 Setting the Button State and Color
To write a Button Color command on an RC button, do the following:
1. Select the BUTTON_COLOR Port.
2. In the RC command area, write the command description (for example,
Change Color).
3. Select the Button ID (from 1 to 6) to which this command refers
1
4. Set the state of the button (On, Off, Fast Blink, Slow Blink), for example, On.
.
5. Set the Button Color (see Figure 41 ).
Figure 40 illustrates the RC Command area as it appears after writing the
command:
Figure 40: Change Color RC Command
1 For example, the command is written to button 1 but refers to an action taken for button 4