Allied Telesis FastPrint Server - Manual (Page 75)

Chapter 8. Management Tools
WebAdmin
FastPrint Server User’s Guide
65
8.2.3.1. Status
These options allow you to check the status of connected printers or FastPrint Servers.
Device information Device information
A list of the current FastPrint Server settings will be displayed.
Printer port status Printer port status
Click the button for any port to check the status of the attached printer, as shown
by the sample screen below.
Figure 33 WebAdmin Port Status
If the printer is bi-directional and is not busy, it can be configured by clicking the
Configuration button. See Printer configuration on page 61 for details.
8.2.3.2. Configuration
These options allow you to configure the current FastPrint.
System System
Allows you to change the FastPrint Server name, and to set the LAN protocol(s)
used by the current FastPrint. Only the Connected protocol referred to on page
67, and your LAN protocol, should be enabled.
Note: By default, all protocols are enabled. This allows operation in any
environment, but degrades performance.
Netware Netware
Configure NetWare with this icon. See NetWare-specific settings on page 19 for
configuration details.
TCP/IP TCP/IP
Use Settings -IP addresses to initially assign an IP address, and this button for
any subsequent changes. See IP address configuration on page 23 for details.
AppleTalk AppleTalk
See AppleTalk Settings on page 8 for details of these configuration settings.
NetBEUI NetBEUI
Allows NetBEUI (Windows SMB) changes to be made. For details, see NetBEUI
Settings on page 59.