Allied Telesis FastPrint Server - Manual (Page 32)

Chapter 4. Novell NetWare
Configuration Settings
FastPrint Server User’s Guide 22
means that printer 8 corres1ponds to logical printer L1, printer 9
corresponds to logical printer L2, and so on, up to printer 15 which
corresponds to logical printer L8.
4.6.3.5.2. Configuring the FastPrint Server
Perform the following steps to define the pre-string, post-string, and the physical output
port of a logical printer:
1. Run PSCONFIG.
2. Select Change Configuration.
3. Select Logical Printer Configuration and set the following items for each logical
port. (Logical printers are numbered from L1 to L8.)
Physical port Select the physical port for this logical printer (P1 to P3).
String before job The printer control string (in hex) to be sent to the printer
before each print job.
String after job The printer control string (in hex) to be sent to the printer
after each print job.
Convert LF to
CR+LF If this is ON, LF (line feed) characters are changed to
CR+LF (carriage return + line feed). If it is OFF, no
conversion will be done.
Note: The maximum size of a printer control string is 15 characters.