beautypg.com

Port menu – Allied Telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT User Manual

Page 99

background image

Allied Telesyn

AT-VIEW PLUS

DEVICE MANAGEMENT

Note

- The current firmware version does not allow the Status parameter to be

configured. Attempting to configure this parameter will result in the error message:
"The error occurred with 'Set' operation. Error: noSuchName."


Security Secrets

Displays information on the identities and secrets used by the PPP authentication
protocols.

Note

-The current firmware version does not allow the Protocol parameter to be

configured. Attempting to configure this parameter will not result in an error but the
new value will not be applied.

Note

- Setting the Status parameter to 'invalid' clears the corresponding values of the

Identity and Secret parameters.

Note

- AT-View Plus Device Manager allows the user to enter up to 63 characters for

the Identity and Secret parameters. Entering more than 63 characters will result in the
error message: "The error occurred with 'Set' operation. Error: bad value."

Note

- Security Secrets parameters return to their default values whenever the device

is restarted.

Port Menu

From the Port menu, you can view and edit MIB information about selected ports.


Interface Info

Displays port statistics such as the number of frames received and transmitted on the port,
bytes received and transmitted on the port, and port status.

Note

- The Interface Info sub-menu option displays port parameters for 20 ports. By default,

the Administration Status parameter is set to 'up' for the first four ports and 'down' for the rest
of the ports. For ports 1 to 3, the Administration Status parameter cannot be configured. Its
value is fixed to 'up'. For ports 5 to 12, valid MIB Set values for the Administration Status
parameter are 'up' and 'down'. Attempting to set this parameter to any other value will result
in the error message: "The error occurred with 'Set' operation. Error: bad value."

Note

- The Administration Status parameter always returns to its default value whenever the

device is restarted.


Error Statistics

Displays error statistics for the port.

PN 613-50507-00 Rev D

Page 99 of 253