Allied Telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT User Manual

Page 35

Allied Telesyn

AT-VIEW PLUS

DEVICE MANAGEMENT

Note

- Attempting to modify the Port Speed and Mode parameter from 'auto sense' to '1Gbps

half-duplex' or '1Gbps full-duplex' will result in the following:

•

An error message: "The error occurred with 'Set' operation. Error: gen Error"

•

Port Speed and Mode parameter value changing to '100Mbps half-duplex'

Note

- The current firmware version does not allow the Port Bridge ID parameter to be

configured. Attempting to configure this parameter will result in the error message: "The
error occurred with 'Set' operation. Error: bad value."

Note

- When a port is set to 'auto sense' and is connected to a half duplex port on another

device, its corresponding Duplex LED on the device image turns green instead of orange.

Note

- The current firmware version does not allow the Port Back Pressure parameter to be

configured. Attempting to configure this parameter will result in the error message: "The
error occurred with 'Set' operation. Error: time out occurred."

Note

- The Port Transmit Pacing Configuration parameter is not applicable to the AT-

8124XL (V2).

Note

- The current firmware version does not allow the Port VLAN Tag Priority and the Port

QoS Priority parameters to be configured. Attempting to configure these parameters will
result in the error message: "The error occurred with 'Set' operation. Error: bad value."

Note

- Valid MIB Set values for the Port State parameter are 'enabled' and 'disabled'.

Attempting to set this parameter to any other value will result in the error message: "The
error occurred with 'Set' operation. Error: bad value.".

Spanning Tree Info

Displays the port's spanning tree parameters.

Enable

Enables the port.

Disable

Disables the port.

Port Mirroring

Displays port mirroring parameters and allows configuration of port mirroring state, source,
and destination.

IGMP Snooping

Displays the current state of IGMP Snooping and allows reconfiguration.

AT-8124XL (V2)

PN 613-50507-00 Rev D

Page 35 of 253