Allied Telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT - Manual (Page 199)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Device Manager LEDs for AT-9812T, AT-9812TF, and AT-9812T-DC
LED State Description
PWR Green
Red
The switch is receiving power from the main power supply.
Main power supply is either off or has failed.
RPS Green
Red
Gray
The switch is receiving power from the redundant power supply.
RPS has failed.
RPS is not installed or RPS monitoring is disabled.
DUPLEX Green
Orange
The port is operating at full duplex.
The port is operating at half duplex.
Note - AT-9812T, AT-9812TF and AT-9812T-DC share the same device image.
Note - To turn RPS monitoring on or off on the switch, from the switch command line interface
enter the command SET SYSTEM RPSMONITOR={ON|OFF}. To see whether RPS monitoring is
on, use the command SHOW SYSTEM. To turn on RPS monitoring using SNMP, set the
fanAndPsRpsMonitoringStatus variable to on.
Note - The current firmware version does not allow AT-View Plus Device Manager to support the
RPS LED on the AT-9812T-DC model.
Agent Menu
From the Agent menu, you can view and edit the system information for the switch, or log into the
CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and description.
Power Supply Info
Displays information about the power supply, redundant power supply and power supply
monitoring.
Firmware Info
Displays a list of software releases installed on the switch.
File List
Displays a list of the files in the switch's file system.
PN 613-50507-00 Rev D Page 199 of 253