Allied Telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT - Manual (Page 25)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note - Valid MIB Set Values for the Port State parameter are 'enabled' and 'disabled'.
Attempting to set this parameter to any other value will result in the error message: "The
error occurred with 'Set' operation. Error: bad value."
Note - The current firmware version does not allow the Port Name parameter to be
configured. Attempting to configure this parameter will result in the error message: "The
error occurred with 'Set' operation. Error: noSuchName".
Spanning Tree Info
Displays the port's spanning tree parameters.
Note - Setting a port's Port parameter to 'disabled' does not automatically set the Port State
parameter under Detail Info to 'disabled'. As a result, the port's image may not turn red as
expected.
Enable
Enables the port.
Note - Under the Sun Solaris platform, the AT-View Plus Device Manager application may
terminate abnormally if multiple ports have been selected and each dialog box with the
message "May I set 'atiswitchPortState.n' to up" is clicked one after the other.
Disable
Disables the port.
Note - Under the Sun Solaris platform, the AT-View Plus Device Manager application may
terminate abnormally if multiple ports have been selected and each dialog box with the
message "May I set 'atiswitchPortState.n' to down" is clicked one after the other.
Port Mirroring
Displays port mirroring parameters and allows configuration of port mirroring state, source,
and destination.
Note - Valid MIB Set values for the Mirroring Destination Port parameter should range from
0 to 24. However, the current firmware version allows the user to enter values up to 65535.
Attempting to enter values greater than 65535 will cause the new value to be converted to its
equivalent wrap-around value; i.e., 65536 will become 0, 65537 will become 1, and so on.
Note - Valid MIB Set values for the Port Mirroring Status parameter are 'receive', 'transmit',
and 'both'. However, the current firmware version does not allow this parameter to be set to
'receive' and 'transmit'. Attempting to do so will result in the error message: "The error
occurred with 'Set' operation. Error: bad value".
PN 613-50507-00 Rev D Page 25 of 253