Allied Telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT - Manual (Page 133)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note - Before hotswapping in the NSM bay, make sure periodic device polling is enabled (File menu
-> Properties).
Note - To turn RPS monitoring on or off on the router, from the AT-AR740 console enter the
command SET SYSTEM RPSMONITOR={ON|OFF}. To see whether RPS monitoring is on, use
the command SHOW SYSTEM. To turn on RPS monitoring using SNMP, set the
fanAndPsRpsMonitoringStatus variable to on.
Note - The current firmware version does not allow AT-View Plus Device Manager to support the
RPS LED on the AT-AR740-DC model.
Agent Menu
From the Agent menu, you can view and edit the system information for the router, or log into the
CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and description.
Power Supply Info
Displays information about the power supply, redundant power supply and power supply
monitoring.
File List
Displays a list of the files in the router's flash file system.
Config File Name
Displays the file name of the start-up configuration file.
Telnet
Starts a Telnet connection to the router.
WEB browser
Opens your web browser and connects to the switch's HTTP server.
Note - The web browser can only contact the device if the device has a valid resource file
loaded and set, and the HTTP server and GUI on the device are enabled.
Routing Menu
From the Routing menu, you can view and edit information about the router's IP routing functions.
ARP Table
Displays the mapping of IP addresses to MAC addresses (the ARP cache) on the router.
PN 613-50507-00 Rev D Page 133 of 253