Allied Telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT - Manual (Page 241)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Note - Valid MIB Set values for the Leave Time parameter are in the range [0-25] inclusive.
Attempting to set this parameter to a value outside the valid range will not result in an error
but the new value will not be applied.
VLAN Info
Displays the VLAN table.
Group Info
Displays a list of all group multicast address.
Server Info
Displays a list of all multicast servers.
VoIP Menu
From the VoIP menu, you can view and edit information related to telephony services available on
the residential gateway.
Note - The current firmware version does not provide the information needed by AT-View Plus
Device Manager to support the H.323 and SIP protocols.
Profile Info
Displays information related to admin profile.
DTMF Relay
Displays Dual Tone Multi-Frequency (DTMF) relay status.
Media
Displays information related to media transport.
QoS
Displays Differentiated Service Code Point (DSCP) entries and its QoS priority level.
MGCP
Protocol Info
Displays general information about the protocol.
Note - Valid MIB Set values for the Default Port parameter are in the range [1024-
2147483647] inclusive. Attempting to set this parameter to a value outside the valid range
will not result in an error but the new value will not be applied.
Note - When setting the Profile parameter to 'none', the current firmware is able to set the
parameter successfully for the CLI but not for SNMP. As a result, AT-View Plus Device
Manager will continue to display the old value.
PN 613-50507-00 Rev D Page 241 of 253