Allied Telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT - Manual (Page 53)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Displays the RMON event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Note - The current firmware version does not allow Port Menu to support the Class of Service.
Utilization
Displays the port's utilization information.
Interface Info
Displays port statistics such as the number of frames received and transmitted on the port,
bytes received and transmitted on the port, and port status.
Note - Valid MIB Set values for the Administration Status parameter are 'up' and 'down'.
Attempting to set this parameter to any other value will result in the following error message:
"The error occurred with 'Set' operation. Error: bad value." This will not affect the
application in any way.
Error Statistics
Displays error statistics.
Detail Info
Displays detailed port information such as duplex mode.
Note - The current firmware version does not support port naming.
Note - When the Port Speed and Mode parameter of a fixed port is set to 'auto sense', the
current firmware version is unable to provide information on the negotiated mode of the port.
As a result, the port's Duplex LED may show up as green when it should really be orange and
vice-versa.
Note - Valid MIB Set values for the Port Speed and Mode parameter of the AT-B17
expansion module ports are '100Mbps full-duplex' or '100Mbps half-duplex'. Attempting to
set this to any other value will result in the error message: "The error occurred with 'Set'
operation. Error: bad value".
Note - Valid MIB Set values for the Port Speed and Mode parameter of the AT-B15
expansion module port are 'auto sense', '1Gbps full-duplex' or '1Gbps half-duplex'.
Attempting to set this to any other value will result in the error message: "The error occurred
with 'Set' operation. Error: bad value".
Note - The Module ID and Port Number parameters return 'noSuchName'.
PN 613-50507-00 Rev D Page 53 of 253