beautypg.com

Port menu – Allied Telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT User Manual

Page 242

background image

Allied Telesyn

AT-VIEW PLUS

DEVICE MANAGEMENT

Call Agent Info
Displays a list of all call agents available.

Port Menu

From the Port menu, you can view and edit MIB information about the ethernet and voice ports.

Utilization

Displays the port's utilization information.


Interface Info

Ethernet
Displays ethernet port statistics such as the number of frames received and transmitted on the
port, bytes received and transmitted on the port and port status.

Note

- Valid MIB Set values for the Port Speed and Mode parameter of the 100Base-FX

WAN ports should only be '100Mbps full-duplex', '100Mbps half-duplex', and 'auto sense'.
However, the current firmware version allows it to be set to '10Mbps full-duplex' or '10Mbps
half-duplex' as well.

Note

- Under the Additional Info sub-menu option, if the Port Speed and Mode parameter is

currently set to '100Mbps full-duplex', it cannot be changed to '100Mbps half-duplex'
directly. You will have to set it to some other speed and mode first. This is true for all LAN
and WAN ports.

Note

- The Port Flow Control parameter has a fixed value of 'flow' and cannot be modified.

Note

- AT-RG613xx : Changing the value of the Port Speed and Mode parameter will result

in the error message: "The error occurred with 'Set' operation. Error: time out occurred."
However, the new value is still set.

Note

- AT-RG656BD : When a LAN or WAN port is configured to auto-negotiate and is

connected to a 100Mbps full or half duplex port on another device, the current firmware
version returns '10000000' for the Speed parameter under the Standard sub-menu option. As
a result, the speed displayed on the RJ-45 LAN port images is '10' instead of '100'.

Note

- AT-RG656BD: The current firmware version returns '???(195)' for the Port Type

parameter of the 100Base-FX WAN port.

Note

- AT-RG656BD : By default, the WAN port is enabled. However, once disabled, it can

no longer be enabled until the device is reset to factory defaults.


PN 613-50507-00 Rev D

Page 242 of 253