Allied Telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT - Manual (Page 87)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Port Menu
From the Port menu, you can view and edit MIB information about hub's ports.
Statistics
Displays port statistics such as number of frames received/transmitted on the port, bytes
received/transmitted on the port and port status.
Status
Displays whether the port is enabled or disabled, whether it is partitioned and other status
information.
Detail Status
Displays information such as port name, LED status and polarity.
Note - A link between a port on the hub and a port on another device can only be established
if the port on the other device is configured to auto-negotiate.
Security Info
Displays source MAC addresses of frames received on the port.
Note - Valid MIB Set values for the Learn Action parameter are 'inactive' and 'active'.
Attempting to set this parameter to any other value will result in the error message "The error
occurred with 'Set' operation. Error: bad value.".
Note - The current firmware version does not allow the user to configure the MAC Address
parameter. Attempting to configure it will result in the error message "The error occurred
with 'Set' operation. Error: bad value.".
Enable
Enables the port.
Disable
Disables the port.
AT-FH800u
PN 613-50507-00 Rev D Page 87 of 253