Allied Telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT User Manual

Page 47

Allied Telesyn

AT-VIEW PLUS

DEVICE MANAGEMENT

Note

- The Port State parameter returns 'unknown' for active ports.

Note -

When a port is configured to auto-negotiate, the current firmware version does not

always update its Port Duplex Status parameter with the correct negotiated mode. As a result,
the port's Duplex LED may show up as green when it should really be orange and vice-versa.

Note -

The Port Speed and Mode parameter of the 1000Base-X port on the AT-A15

expansion module can only be set to '1Gbps full-duplex'. Attempting to set this to any other
value will result in the error message: "The error occurred with 'Set' operation. Error: gen
Error".

Note -

The Port Speed and Mode parameter of the 100/1000Base-T port on the AT-A14

expansion module can only be set to 'auto'. Attempting to set this to any other value will
result in the error message: "The error occurred with 'Set' operation. Error: gen Error".

Note -

The Port Speed and Mode parameter of the 100Base-FX port on the AT-A16, AT-

A17, and AT-A19 expansion modules can only be set to '100Mbps full-duplex'. Attempting
to set this to any other value will result in the error message: "The error occurred with 'Set'
operation. Error: gen Error".

Note -

Valid MIB Set values for the Port State parameter are 'enabled' and 'disabled'.

Attempting to set this parameter to any other value will result in the error message: "The
error occurred with 'Set' operation. Error: bad value."

Enable

Enables the port.

Note -

Expansion module ports cannot be enabled. Attempting to do so will result in the error

message: "The error occurred with 'Set' operation. Error: gen Error".

Disable

Disables the port.

Note -

Expansion module ports cannot be disabled. Attempting to do so will result in the

error message: "The error occurred with 'Set' operation. Error: gen Error".

Port Mirroring

Displays port mirroring parameters and allows configuration of port mirroring state, source,
and destination.

PN 613-50507-00 Rev D

Page 47 of 253