Allied Telesis AT-S63 - Manual (Page 324)

Chapter 22: TACACS+ and RADIUS
324 Section IV: Security
Enabling or Disabling TACACS+ or RADIUS
To enable or disable the authentication protocols, perform the following
procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40
2. Select the Server-based Authentication tab.
The Server-based Authentication tab is shown in Figure 123.
Figure 123. Server-based Authentication Tab (Configuration)
3. To select an authentication protocol, in the Authentication Method
section of the tab, click either RADIUS or TACACS+. The default is
TACACS+.
Note
The switch can support only one authentication protocol at a time.
Additionally, you cannot select a different authenticator protocol
when this feature is enabled.
4. To enable or disable the authentication feature on the switch, click the
Enable Server-based Authentication check box. A check in the box
indicates that this feature is enabled. No check indicate the feature is
disabled. The default is disabled.
5. Click Apply.
To configure TACACS+, go to ”Configuring TACACS+”, next. To
configure RADIUS, go to ”Configuring RADIUS” on page 329-.