Allied Telesis AT-S63 - Manual (Page 205)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 205
Enabling or Disabling SNMP Management
In order to allow an SNMP manager or host to access the switch you
need to enable SNMP access. In addition, to allow the switch to send a
trap when it receives a login attempt from an unauthenticated user, you
need to enable authentication failure traps. This section provides a
procedure to accomplish both of these tasks.
To enable SNMP access and authentication failure traps, perform the
following procedure:procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69.
Figure 69. SNMP Tab (Configuration)