Allied Telesis AT-S63 - Manual (Page 242)

Chapter 16: SNMPv3
242 Section II: Advanced Features
7. To save your changes, return to the General tab and click Save
Changes.
Modifying
Target Address
Table Entry
To modify an entry in the SNMPv3 Target Address Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Target
Address Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Address Table tab is shown in Figure 85 on
page 239.
4. Click Next or Previous to display the Target Address Table entry that
you want to change.
5. Click Modify.
The Modify SNMPv3 Target Address page is shown Figure 87.
Figure 87. Modify SNMPv3 Target Address Page
6. In the IP Address field, enter the IP address of the host.