Allied Telesis AT-S63 - Manual (Page 192)

Chapter 15: MSTP
192 Section II: Advanced Features
Adding, Removing, or Modifying VLAN Associations to MSTIs
This section explains how to add or remove VLANs associated to MSTI
IDs.
Adding a VLAN
Association
To add a VLAN association, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected
by default, as shown in Figure 23 on page 90.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 51 on page 164.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 62 on
page 185.
5. In the CIST/MSTI Table section of the tab, the VLAN Associations field,
enter the VIDs of the VLANS to be associated with this MSTI. You can
specify more than one VID at a time (for example, 2,4,7).
6. Click Apply.
7. To permanently save the change, return to the General tab on the
System page and click Save Changes.
For more information about what the Save Changes button does,
refer to ”Saving Your Parameter Changes” on page 36.
Or, proceed to the next procedure to configure the CIST priority.
Removing a
VLAN
Association
To remove a VLAN association, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected
by default, as shown in Figure 23 on page 90.