Allied Telesis AT-S63 - Manual (Page 183)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 183
4. To change the active spanning tree protocol on the switch, click STP,
RSTP, or MSTP in the Active Protocol Version section of the tab. The
default is RSTP.
Note
Only one spanning tree protocol can be active on the switch at a
time.
5. To enable or disable the active spanning tree protocol on the switch,
click the Enable Spanning Tree check box. A check indicates that the
spanning tree is enabled while no check indicates that spanning tree
is disabled. The default is disabled.
6. Click Apply.
Note
If you changed the active spanning tree protocol, the switch resets
and your management session is ended. To continue managing the
switch, you must restart your management session after the switch
is finished reloading the AT-S63 management software.
7. If you activated STP, go to ”Configuring STP” on page 166. If you
activated RSTP go to ”Configuring RSTP” on page 174. If you activated
MSTP, go to ”Configuring MSTP” on page 184.