Allied Telesis AT-S63 - Manual (Page 178)

Chapter 14: STP and RSTP
178 Section II: Advanced Features
10. To permanently save the change, return to the General tab on the
System page and click Save Changes.
For more information about what the Save Changes button does,
refer to ”Saving Your Parameter Changes” on page 36.
Note
All changes to a port’s RSTP settings, with the exception of port cost,
are activated immediately. A change to the port cost value requires
you to reset the switch. A new port cost value is not implemented
until the unit is reset.
Resetting RSTP
to the Default
Settings
To reset RSTP to the default settings, perform the following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select Layer 2.
The Layer 2 page is displayed with the MAC Address tab shown by
default, as shown in Figure 23 on page 90.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 51 on page 164.
4. Click Configure.
The Configure RSTP Bridge Parameters tab is shown in Figure 57
on page 175.
5. Click Defaults.
The RSTP defaults are shown in ”STP, RSTP, and MSTP Default
Settings” on page 369.
Displaying
RSTP Settings
To display RSTP parameter settings, perform the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 44.
2. From the Monitoring menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab displayed
by default, as shown in Figure 25 on page 94.
3. Select the Spanning Tree tab.