Allied Telesis AT-S63 - Manual (Page 230)

Chapter 16: SNMPv3
230 Section II: Advanced Features
9. Click Apply.
10. To save your changes, return to the General tab and click Save
Changes.
Deleting a
SecurityToGroup
Table Entry
To delete an entry SNMPv3 SecurityToGroup Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure
SecurityToGroup Table, and then click Configure at the bottom of
the tab.
The SNMPv3 SecurityToGroup Table tab is shown in Figure 79 on
page 228.
4. Click the button next to the SecurityToGroup Table entry that you
want to delete and then click Remove.
A warning message is displayed.
5. Click OK.
6. To save your changes, return to the General tab and click Save
Changes.
Modifying a
SecurityToGroup
Table Entry
To modify an entry SNMPv3 SecurityToGroup Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure
SecurityToGroup Table and then click Configure at the bottom of
the tab.
The SNMPv3 SecurityToGroup Table tab is shown in Figure 79 on
page 228.