Allied Telesis AT-S63 - Manual (Page 204)

Chapter 16: SNMPv3
204 Section II: Advanced Features
Configuring the SNMPv3 Protocol
To configure the SNMPv3 protocol, you need to first enable SNMP access
on the switch. Then you configure the SNMPv3 tables. See the following
procedures:
❑ ”Enabling or Disabling SNMP Management” on page 205
❑ ”Configuring the SNMPv3 User Table” on page 207
❑ ”Configuring the SNMPv3 View Table” on page 214
❑ ”Configuring the SNMPv3 Access Table” on page 220
❑ ”Configuring the SNMPv3 SecurityToGroup Table” on page 227
❑ ”Configuring the SNMPv3 Notify Table” on page 233
❑ ”Configuring the SNMPv3 Target Address Table” on page 238
❑ ”Configuring the SNMPv3 Target Parameters Table” on page 245
❑ ”Configuring the SNMPv3 Community Table” on page 252
Note
Use the SNMPv3 Community Table only if you are configuring the
SNMPv3 protocol with an SNMPv1 or an SNMPv2c implementation.
Allied Telesyn does not recommend this configuration.
For reference information about the SNMPv3 protocol, see Chapter 18,
“SNMPv3,” in the AT-S63 Management Software Menus Interface User’s
Guide.