Allied Telesis AT-S63 - Manual (Page 245)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 245
Configuring the SNMPv3 Target Parameters Table
You can create, delete, and modify an SNMPv3 Target Parameters Table
entry. See the following procedures:
❑ ”Creating a Target Address Table Entry” on page 238
❑ ”Deleting a Target Address Table Entry” on page 241
❑ ”Modifying Target Address Table Entry” on page 242
For reference information about the SNMPv3 Target Parameters Table,
see Chapter 18, “SNMPv3” in the AT-S63 Management Software Menus
Interface User’s Guide.
Creating a
Target
Parameters
Table Entry
To create an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Target
Parameters Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Parameters Table tab is shown in Figure 88.
Figure 88. SNMPv3 Target Parameters Table Tab (Configuration)
4. Click Add.