Allied Telesis AR700 SERIES Software Release 2.7.1 User Manual
Page 95
95
Software Release 2.7.1
C613-02047-00 REV A
2.
Configure Frame Relay.
To configure a Frame Relay interface over a synchronous port to Router D,
and add a data link circuit to the Frame Relay interface, enter the
commands:
create framerelay=0 over=syn0 lmischeme=none
add framerelay=0 dlc=20
3.
Configure ISDN.
Set up an ISDN call to Router A for DVMRP multicast traffic. This call
must have the same name as the ISDN call from Router A, and the opposite
precedence. Enter the command:
add isdn call=dvmrp outsub=local searchsub=local
precedence=in num=7654321
4.
Configure PPP.
To configure a PPP interface over the ISDN interface, enter the command:
create ppp=0 over=isdn-dvmrp idle=on
5.
Configure IP.
To enable the IP module, and assign IP addresses to the interfaces, enter the
commands:
enable ip
add ip interface=fr0 ipaddress=202.96.152.12
mask=255.255.255.0
add ip interface=ppp0 ipaddress=203.45.90.3
mask=255.255.255.0
add ip interface=eth0 ipaddress=172.74.2.3
mask=255.255.255.0
6.
Configure IGMP.
To enable IGMP on the router and on the interfaces over which group
membership is to be managed, enter the commands:
enable ip igmp
enable ip igmp interface=eth0
enable ip igmp interface=ppp0
enable ip igmp interface=fr0
7.
Configure DVMRP.
Enable DVMRP on the router, and assign the interfaces over which
DVMRP will perform multicast routing. Enter the commands:
enable dvmrp
add dvmrp interface=eth0 metric=1
add dvmrp interface=ppp0 metric=3
add dvmrp interface=fr0 dlc=20 metric=6