Allied Telesis AR700 SERIES Software Release 2.7.1 - Manual (Page 66)

66 AR700 Series Router User Guide
Software Release 2.7.1
C613-02047-00 REV A
To display the modules in the router that are configured to use an Ethernet
interface, and the encapsulations used on an interface, enter the command:
show eth=n configuration
where n is the number of the Ethernet interface.
For more information about Ethernet interfaces and encapsulations, see the
Interfaces chapter in the Software Reference.
Asynchronous Port
Asynchronous ports are normally used to connect a terminal to the router for
configuration purposes. The default values for configurable parameters are
modified by entering the command:
set asyn=port-number option
The factory default settings for asynchronous ports are shown in Table 8 on
page 66 .
For more information about asynchronous ports, see the Hardware Reference
or the Interfaces chapter in the Software Reference.
Table 8: Factory defaults for configurable parameters for asynchronous ports.
Option Default setting
ATTENTION BREAK
CDCONTROL IGNORE
DATABITS 8
DEFAULTSERVICE FALSE
DTRCONTROL ON
ECHO ON
FLOW HARDWARE
HISTORY 30
INFLOW HARDWARE
IPADDRESS NONE
IPXNETWORK NONE
MAXOQLEN 0 (Unrestricted)
MTU 1500
NAME Asyn #
OUTFLOW HARDWARE
PAGE 22
PARITY NONE
PROMPT DEFAULT (CMD>)
SECURE ON
SERVICE NONE
SPEED AUTO
STOPBITS 1
TYPE VT100