Red Lion LEGEND - Manual (Page 56)

INSTALLATION & REMOVAL OF RELAY BOARD
To install the relay board, locate the relay opening at the lower right-hand
corner, on the back of the Legend Plus. Using a small screwdriver, inserted into
the slot of the relay latch, bend the tab down while sliding the board into the two
slots in the housing. The relay board will seat into the unit, allowing the tab to
return to its original position. To remove the relay board, pull down on the tab just
enough to allow the relay board to slide out. Grasp the terminal block and pull to
remove the board.
DIP SWITCH SET-UP
The DIP switches are accessible through the side of the Legend Plus. The DIP
switch positions and their functions are shown below:
-54-