Red Lion LEGEND - Manual (Page 33)

MESSAGE TEXT
A message can contain up to 200 characters. The keypad can be used to perform
message editing functions such as; scrolling through message text, inserting and
deleting characters, toggling from upper/lower case, toggling from
Extended/Standard ASCII characters sets, etc. Refer to table below for text editing
key functions. Message Text and other message parameters may also be
programmed utilizing the optional Legend Plus Programming Software.
Before entering message text, the message type (1L/2L Block or Scroll) should
be configured. This selection will affect the formatting of the message text. When
entering block messages, an end of line character and an end of block character can
be used to conserve message memory. The End of Line character is displayed as a
small open square. It is used only on the top line in 2 line block messages. If there is
more than one space at the end of the top line, the End of Line character should be
inserted after the last non space character. The End of Block character is displayed
as a large open block. It can be inserted after the last character of a message block
on either display line. Message blocks that contain only End of Line and/or End of
Block characters will be blank when displayed. The End of Line or End of Block
are not used in character scrolling messages (1L or 2L Scrol).
The Last character in a message is the End of Message character, which is
displayed as a large solid block. The End of Message character cannot be edited.
Text Editing Key Functions: Keys Pushed
Scroll through characters ^ or v
Select Character position > or <
Reset to “A” character F1 + ^
Reset to the space character F1 + v
Insert space Character, push right F1 + >
Delete character, pull left F1 + <
Insert End of Line 1 Character F1 + PRS
Insert End of Block Character or
Numeric Field Position (Custom Disp. lines)
F1 + ENT
Upper/Lower Case toggle F2 + ^
Toggle between Extended & Standard Character F2 + v
SPECIAL USE CHARACTERS
n - End of Line 1
[] - End of Block
z
- End of Message (Non editable)
Note: In message and mnemonic text entry, the F1 & F2 User Input functions are
disabled.
ASCII TABLE OF STANDARD CHARACTERS
-31-
HEXA
DECIMAL DECIMAL
LEGEND
CHARACTER
80 128 З
81 129 ь
82 130 й
83 131 в
84 132 д
85 133 а
86 134 е
87 135 з
88 136 к
89 137 л
8A 138 è
8B 139 ï
8C 140 î
8D 141 ì
8E 142 Ä
8F 143 Е
90 144 Й
91 145 ж
92 146 Ж
93 147 ф
94 148 ц
HEXA
DECIMAL DECIMAL
LEGEND
CHARACTER
95 149 т
96 150 ы
97 151 щ
98 152 я
99 153 Ц
9A 154 Ü
9B 155 ¢
9C 156 £
9D 157 ¥
9E 158 Á
9F 159 Í
A0 160 á
A1 161 í
A2 162 ó
A3 163 ú
A4 164 ñ
A5 165 Ñ
A6 166 Ó
A7 167 Ú
A8 168 ¿