HP PCIe IO Accelerators for ProLiant Servers - Manual (Page 36)

Linux environments 36
The SNMP Agentx now replaces any existing IO Accelerator driver data it has with any populated fields
in the list of parameters. If a field is not populated, Agentx retains the existing data and reports it to the
MIB. If a value in a field is present, then the Agentx replaces that data and reports it to the MIB.
Agentx continues in test mode until the .ini file parameter is set to OFF. The test mode information is
described in the testmode.ini file:
# SNMP Test Mode sample file.
# These values may be used to test the SNMP subsystem when it is in test
mode.
[SNMP Agent Test Mode] TestMode = off
TestModeIndex = 0
# InfoState: Note that the following states may change, but current
definitions are:
# 0 = unknown
# 1 = detached
# 2 = attached
# 3 = minimal mode
# 4 = error
# 5 = detaching
# 6 = attaching
# 7 = scanning
# 8 = formatting
# 9 = updating firmware
# 10 = attach
# 11 = detach
# 12 = format
# 13 = update
InfoState
= 2
InfoCurrentTemp
= 72
InfoWearoutIndicator = 2 ; 2=normal, 1=device is wearing out.
InfoNonWritableIndicator = 2
; 2=normal, 1=device is wearing out.
InfoFlashbackIndicator = 2 ; 2=normal, 1=flashback protection
degraded.
ExtnTotalPhysCapacityU
= 23
ExtnTotalPhysCapacityL = 215752192
ExtnUsablePhysCapacityU = 21
ExtnUsablePhysCapacityL = 7852192