HP PCIe IO Accelerators for ProLiant Servers User Manual
HP Computer Accessories
Table of contents
Document Outline
- HP PCIe IO Accelerator for ProLiant Servers User Guide
- Notice
- Contents
- About this guide
- Introduction
- Hardware installation
- Linux environments
- Linux installation requirements
- Downloading and installing the driver and utilities using Linux
- Loading the IO Accelerator driver using Linux
- Setting the driver options
- Upgrading firmware using Linux
- Uninstalling and upgrading the driver using Linux
- Using the IO Accelerator as swap with Linux
- Using the Logical Volume Manager
- Configuring RAID for Linux
- Setting up SNMP for Linux
- Windows Server environments
- Uninstalling a previously-installed driver
- Installing software on a Windows system
- Manual installation on Windows Server
- Upgrading the device firmware using Windows
- Upgrading driver software using Windows
- Defragmentation
- IO Accelerator naming
- Adding a file system, formatting, and performing multi-disk configuration
- Creating a RAID configuration
- Using the IO Accelerator as swap with Windows operating system
- Setting up SNMP for Windows operating systems
- Using installation logs
- VMWare ESX environments
- Creating the ESX IO Accelerator driver CD
- Installing the driver as part of a new ESX installation
- Installing the driver using vihostupdate
- Installing the driver using esxupdate
- Installing the IO Accelerator utilities using ESX
- Configuring the IO Accelerator using ESX
- Upgrading the firmware using ESX
- Working with IO Accelerator devices and PCI pass-through
- Using the IO Accelerator as swap with ESX
- Disabling the driver using ESX
- Enabling the driver using ESX
- Uninstalling the driver utilities using ESX
- HP IO Accelerator Management Tool
- Maintenance
- Utilities
- Monitoring IO Accelerator health
- Trim support (Windows only)
- Using Windows page files with the IO Accelerator
- Resources
- Technical support
- Regulatory compliance notices
- Acronyms and abbreviations
- Index