HP Smart Storage Administrator - Manual (Page 94)

Operations 94
HP SSA scripting warning messages
Warning
code
Warning message Comment or clarification
4000 License key is already installed The input file specified a license key. However, a
license key is already installed on the controller.
4001 Clear configuration command failed -
configuration is already cleared
The -reset option was used on a controller that
does not have a configuration.
4002 Chassis name is already set to this value The chassis name is already set to the supplied
value. The command is ignored.
4003 One or more controller commands were
skipped because the controller is not
configured
Certain commands require that the controller be
configured before they can be sent to the controller.
4004
Using Repeat function Some commands have been ignored because the
Repeat parameter has been specified in the input
file.
4005 The system must be rebooted for the firmware
flash to complete
A controller has been flashed with new firmware.
The new firmware requires a reboot to take effect.
4006 Unable to set the array accelerator for this
volume. The cache board may be missing or
have a bad status, or the controller may not
support a cache
The controller may not support a cache (for
example, some Software RAID controllers) or the
cache may be missing or defective.
4007 The controller does not have a battery
attached
The operation requested requires a battery and one
was not attached.
4008 The controller battery status is Failed The operation requires a battery and the attached
battery has failed.
4009 This parameter cannot be modified The input script attempted to modify a parameter
which is not modifiable.
4010 Rapid Parity Initialization is not available Rapid Parity Initialization is not available on the
selected volume; there may already be an RPI in
progress, or the firmware does not support RPI.
4011
The command is not available when
MODE=CONFIG
—
4012 The command is not availbale when
MODE=RECONFIG
—
HP SSA scripting error messages
Error code Error message Comment or clarification
0 — No error exists. The program completed
successfully.
2053 Too many coinciding expansion, migration,
or extension operations The new configuration requires more
transformations than are possible at one time. For
example, you cannot expand a logical volume and
transform its RAID level at the same time.
2056 Controller does not support license keys The controller does not support license key entry or
deletion.
2059 Invalid license key The entered license key is not a valid license key.
2064 Controller does not support SSP The controller does not support SSP functions.
2817 Invalid Action The requested actions are invalid, for example,