HP Smart Storage Administrator - Manual (Page 42)

Operations 42
• All existing logical drives in the source array must be in OK state.
• The destination array must have sufficient capacity to hold all logical drives present in the source array.
Setting Auto RAID 0
CAUTION: If you select this option for any logical drives, you will experience data loss for that
logical drive if one physical drive fails. Assign RAID 0 to drives that require large capacity and
high speed, but pose no data safety risk.
Auto Array RAID 0 creates a single RAID 0 volume on each physical drive specified, enabling the user to
select multiple drives and configure as RAID 0 simultaneously. Each array contains one physical drive and
one RAID 0 logical drive.
For more information about RAID 0, see "RAID 0—No fault tolerance (on page
109 )."
To create an array with RAID 0:
1. Open HP SSA.
For more information, see "Using the HP SSA GUI (on page
16 )."
2. Select the controller.
3. Click Create Arrays with RAID 0.