The show command – HP Smart Storage Administrator User Manual
Page 50
Operations 50
Keyword
Abbreviation in HP
SSA CLI
Keyword
Abbreviation in HP
SSA CLI
exitonerror
eoe
surfacescandelay
ssd
expandpriority
ep
surfacescanmode
ssm
inconsistencyrepairpolicy
irp
sufacescanpriority
sp
licensekey
lk
surfacescanschedule
sss
logicaldrive
ld
tapedrive
td
mnpdelay
mnpd
waitforcacheroom
wfcr
*The CLI also uses this keyword and abbreviation for the terms box name and RAID array ID.
The show command
The show command enables you to obtain information about a device.
Syntax:
When you specify a target that consists of several devices, the information in the output is normally less
comprehensive than when you specify only one device as the target. You can use the [detail] parameter
in this case to retain all the information usually given for individual devices.
An extra parameter is available for controller targets: config. This parameter is used as follows:
If you use the config parameter, the output includes information about each device connected to the
controller.
Example 1:
=> ctrl slot=9 show
A typical output would be:
Smart Array P421 in Slot 9
Bus Interface: PCI
Slot: 9
Serial Number: PBKTV0XTAZZ005
RAID 6 (ADG) Status: Enabled
Controller Status: OK
Hardware Revision: A
Firmware Version: 0.02-106
Rebuild Priority: Medium
Expand Priority: Medium
Surface Scan Delay: 3 secs
Surface Scan Mode: Idle
Queue Depth: Automatic
Monitor and Performance Delay: 60 min
Elevator Sort: Enabled
Degraded Performance Optimization: Disabled
Inconsistency Repair Policy: Disabled
Wait for Cache Room: Disabled
Surface Analysis Inconsistency Notification: Disabled