Setting switch snmp properties, 34 switch firmware update wizard, Setting switch snmp – HP 8.20q Fibre Channel Switch User Manual
Page 51: Properties, Step 9
HP StorageWorks Simple SAN Connection Manager user guide
51
9.
On the completed Switch Firmware Update wizard window (
), click Next.
Figure 34
Switch Firmware Update wizard
10.
To complete the wizard, choose one of the following options:
• To confirm and proceed with the firmware update, click Finish.
• To change your selections for the firmware update, click Back.
• To stop the firmware update, click Cancel.
If you clicked Finish, a message may inform you that the switch firmware is ready to be updated. The
process takes several minutes per switch and cannot be canceled. Also, switch traffic may be
temporarily disrupted.
11.
Click Yes when prompted to update the switch firmware.
Setting switch SNMP properties
Use the SNMP Properties dialog box to define how authentication traps are managed and set for the
switch.
To set the switch SNMP properties:
1.
To access the SNMP Properties, choose one of the following options:
• On the HBA & Switch Management menu, click Set Switch SNMP Properties. (If you have more than
one switch in your SAN, the Switch Selection dialog box prompts you to select a switch, and then
click OK.)
• In the content pane’s Physical Connection map, right-click a specific switch icon, and then on the
shortcut menu, click Set Switch SNMP Properties.