HP 8.20q Fibre Channel Switch - Manual (Page 33)

HP StorageWorks Simple SAN Connection Manager user guide 33
Figure 15 Initialize an Enterprise Virtual Array (EVA) Storage Subsystem dialog box
3. Enter a name to identify this new storage subsystem array, and then click OK to initialize the subsystem
using the default configuration. (This step is not required for MSA storage.)
4. Wait while the application discovers (detects) new switches, storage subsystems, and logical disks. This
may take a few minutes.
If the application detects a new, unconfigured switch in your SAN, the New Switch Setup dialog box
( Figure 16 ) opens.
Figure 16 New Switch Setup dialog box
The New Switch Setup dialog box prompts you to set up the new switch by completing these three
steps:
1. Set switch IP address
2. Set switch administrator password
3. Set switch zoning: HBA zoning