HP 8.20q Fibre Channel Switch - Manual (Page 49)

HP StorageWorks Simple SAN Connection Manager user guide 49
2. If a specific switch is selected, click Next and go to step 4 . If no specific switch is selected, the wizard
( Figure 32 ) prompts you to select one or more switches; go to step 3 .
Figure 32 Switch Firmware Update Wizard: selecting a switch
3. In the Switch Firmware Update wizard’s Available Switch(es) list, select one or more switches for which
you want to update the firmware as follows:
a. Choose one of the following options:
• Select a switch on the Available Switch(es) list, and then click Add.
• To select all of the available switches, click Add All.
b. Click Next. (Next is disabled until you select at least one switch and add it to the Selected
Switch(es) list.)
NOTE: If you select and add a switch by mistake, select that switch on the Selected Switch(es) list,
and then click Remove. To clear the Selected Switch(es) list and start the selection again, click
Remove All.
The wizard window lists switches selected for firmware update. The list provides the following
information:
• Switch name.
• Current switch firmware version.
• Firmware image file name (this field is blank until you click and complete Select Switch Firmware
File—see step 4 ).
• Switch administrator password for authentication (this field is blank until you click and complete
Switch Admin Password—see step 6 ).
• Option to apply the new firmware image right after the update or wait until the next time the switch
is turned off, and then back on. (This field is blank until you click and complete Switch Admin
Password—see step 6 ).